⬤Pixel level brightness and chroma calibration Work with NovaStar’s high-precision calibration system to calibrate the brightness and chroma of each pixel, effectively removing brightness differences and chroma differences, and enabling high brightness consistency and chroma consistency. ⬤Quick adjustment of dark or bright lines The dark or bright lines caused by splicing of modules and cabinets can be adjusted to improve the visual experience. The adjustment can be easily made and takes effect immediately. ⬤3D function Working with the sending card that supports 3D function, the receiving card supports 3D image output. ⬤Individual gamma adjustment for RGB Working with NovaLCT (V5.2.0 or later) and the controller that supports this function, the receiving card supports individual adjustment of red gamma, green gamma and blue gamma, which can effectively control image non- uniformity at low grayscale conditions and white balance offset, allowing for a more realistic image. ⬤Image rotation in 90° increments The display image can be set to rotate in multiples of 90° (0°/90°/180°/270°).RoHS, EMC Class A⬤Mapping function The cabinets can display the receiving card number and Ethernet port information, allowing users to easily obtain the locations and connection topology of receiving cards. ⬤Setting of a pre-stored image in receiving card The image displayed on the screen during startup, or displayed when the Ethernet cable is disconnected or there is no video signal can be customized. ⬤Temperature and voltage monitoring The receiving card temperature and voltage can be monitored without using peripherals. ⬤Cabinet LCD The LCD module of the cabinet can display the temperature, voltage, single run time and total run time of the receiving card.⬤Bit error detection The Ethernet port communication quality of the receiving card can be monitored and the number of erroneous packets can be recorded to help troubleshoot network communication problems. NovaLCT V5.2.0 or later is required. ⬤Firmware program readback The receiving card firmware program can be read back and saved to the local computer. NovaLCT V5.2.0 or later is required. ⬤Configuration parameter readback The receiving card configuration parameters can be read back and saved to the local computer. ⬤Loop backup The receiving card and sending card form a loop via the primary and backup line connections. If a fault occurs at a location of the lines, the screen can still display the image normally.